100" Curved Fire Pit Frame with Electronic Ignition Burner
Prefabricated fire pit featuring a 72" curved burner.
Ideal for commercial and residential projects requiring the convenience and safety of an electronic burner system.
Specifications:
- Heavy duty frame construction
- 150,000 btu's
- 72" Stainless steel tube burner
- Stainless steel burner pan
- Key valve assembly includes: Brass valve, decorative flange and key
- Stainless steel flexible gas line for convenient gas connection
- Top decking: 4" width
- Available in natural or propane gas
Electronic Ignition Burner System:
- 24VAC burner system includes a transformer/power supply (Nema 3R electrical enclosure)
- Electrical requirement: 120VAC from source to power supply. Low voltage (24VAC) from power supply to solenoid and burner
- Emergency shut off switch is recommended. Refer to installation supplies for purchasing
How to make template of curved frame
Radius is the length of line from center of circle to the perimeter
- Cut a string 61 1/4" in length
- Hold one end of string in a fixed position
- Tie a pencil to other end of string and draw arc
- Measure 106" around arc
Buyers Guide:
- Timer and emergency stop switch sold separately- see our installation supplies
- Burner must be covered when not in use. Custom metal and fabric cover available
- Prefabricated fire pit allows you to be creative finishing the exterior of frame
- Continue shopping for installation supplies and fire pit accessories to enhance the flame.
- Flame Creation products include: fire glass, lava rock, river stones, covers, timers, safety shut off switches, vents
- Electronic burners require outdoor approved wire with conduit from source (breaker and switch) to fire pit location
- GFCI protected circuit must be utilized
- Ventilation required
Refer to dimensions below to confirm size and degree of arc is ideal for your application. Create a cardboard template to assist.
Fire Glass Information:
- 100 lbs of fire glass is recommended for natural gas applications
- 75 lbs of fire glass is recommended for propane gas applications
- Propane applications: Apply up to 1/4" of fire glass over burner. Do not block burner holes with media
- Burner pilot area and pilot hood must be clear of any media or debris to operate
- LP Gas Warning: Do not exceed 1/4" depth of fire glass or small lava rock directly over burner. Applying too much media may result in gas pooling in fire pit. Ventilation required to allow fresh air into enclosure and any residual gas to escape
Options:
- Electronic Ignition Control Type:
- On/Off Operation: Burner system turns on/off with wall switch, remote, timer or home automation (purchased separately)
- On/Off Operation with Remote: Includes remote and receiver which can be plugged into an approved outlet (purchased separately)
- Gas Key Valve Kit allows for manual flame height adjustment
- Valve kit includes: brass valve, decorative valve cover, flexible gas line and choice of 3", 8", 12", 18" key
Frame Dimension: 97" (top arc), 73" (inside arc), 18" width
*Actual finish size will be determined by material used to complete outside of fire pit frame. *Dimensions can vary by +/- 1"
Fire Pit Pan Dimensions: 84" (top arc), 10" wide
Custom Sizes Available
Sales and Technical 770-963-7999
