Rectangle Metal Covers
Custom cover for square fire pits.
All Sizes Available.
Choice of one or two handles.
Decorative media should not extend above coping more than 2" for cover to fit
- 304 Stainless Steel
- Stainless Steel Handle
- Brushed finish
- Cover height: 2"
How to order covers to fit on top of coping:
- Measure inside opening of fire pit. Cover should extend at least 1" over coping
- Example: Opening is 30" add 2". During check-out choose 32" cover
How to order covers fitting inside of coping:
- Measure inside opening of fire pit. Cover must be smaller than measurement to fit
- Example: Opening is 30 1/2". Choose cover 30"
- Please provide actual dimensions of fire pit opening for covers fitting inside coping ledge
- Dimensions can be provided in Special Instructions at check-out
- Lava rock or media should not be filled more than 2" above finished coping for cover to fit
- Cover height can be fabricated taller than 2". Additional charges apply.
- Two handles is recommended for covers with lengths greater than 4 ft. for easier lifting
- Use a general purpose scour pad for removing light surface scratches
- The underside of cover is polished stainless steel. This side of cover may have scratches or blemishes which occurs during fabrication. When cover is installed on fire pit this side of cover will not be seen.
- How much does a cover weigh? Example 30" x 30" = 18 lbs
Custom sizes available: 770-963-7999
Lead Time for Fabrication: 7 to 10 days