60" Curved Fire Pit Pan

(No reviews yet) Write a Review
60" curved fire pit pan and burner

60" Curved Fire Pit Pan with 54" Curved Burner
Call for additional information on custom sizes and electronic ignition burner systems.                                                                          

  • Radius: 47 3/4"
  • 100,000 BTU's
  • 16 gauge stainless steel
  • 6" x 6" access plate provided in center of pan
  • Gas connection located in center of burner (1/2" npt)
  • Hole provided in center of access plate for gas connection

Pan Dimensions:

  • Outside arc: 60"
  • Inside arc: 51 1/2""
  • Width: 8"
  • Depth: 2"
  • Arc dimensions can vary +/- 1 inch

Buyers Guide (How to make template of curved pan)
Radius is the length of line from center of circle to the perimeter

  1. Cut a string 47 3/4" in length
  2. Hold one end of string in a fixed position
  3. Tie a pencil to other end of string and draw arc
  4. Measure 51 1/2" around arc to determine inside arc of pan
  5. Cut a string 55 3/4" and follow above steps.  Measure 60" around arc to determine outside arc

General Information:  

  • Access plate allows access to inside of fire pit for installing gas lines and servicing propane conversion fitting
  • Continue shopping to purchase whistle free flexible gas line for connecting to access plate

Natural gas information:

  • 50 lbs of fire glass will fill fire pit pan
  • Additional glass may be required to fill to desired height depending on thickness of ledge. (Natural gas only)

Liquid propane gas information:

  • LP gas air mixer fitting will reduce sooting and produce a more realistic flame appearance
  • LP conversion fitting should be installed on bottom side of access plate per instructions
  • Ventilation must be provided at the base of propane fire pits for safe operation
  • Do not install more than 1/4" of fireglass or small lava rock above burner holes
  • Do not block burner holes with media

* Custom sizes available

Prop 65 warning (CA residence)